Tips on cleaning your drill press

You needn’t go to extreme lengths to clean your drill press, but there’s a set of rules everyone has to follow once in a while if they’re all for prolonging the life of their machine. Both accuracy and drilling performance can be affected if the components are dirty and worn out. That’s why it’s important to take the drill press apart from time to time and examine the condition of the drive belt, spindle and chuck, pulleys, column, and even the table.

Some machines can be affected by rust, and that’s no friend of ours as it can have an adverse impact on the functionalities and the overall way that the drill press is capable of serving you. It’s important to get a rust remover and clean heavier deposits, at least on occasion.


Lighter grime can be dealt with with a solvent or degreaser that’s available at most stores near you. Many of the cheap ones that you’ll find in any shop are just as good as their higher priced counterparts, so if you’re not looking to spend a fortune on such substances, my advice would be to invest in a couple of budget-friendly ones.


The main issue is that most drill press users fail to understand that preventing a problem such as corrosion can be done efficiently and with as little effort as possible as long as you’re willing to preserve your machine in top shape for future tasks. For example, if you’re not a great friend of rust, I recommend a protective spray like the Bullfrog Rust Blocker. It’s not particularly expensive, so I’d like to point out once again that you needn’t break your piggy bank for this purpose. The protective spray should be used on any metal surfaces that are bare, including the chuck, the column, or the table.


Something that has helped me in the past was to keep the machine clean right after wrapping up a task. I know that sometimes, it can be rather hard to clean right after yourself once you’ve decided that you’re done with using your drill press. However, I have to emphasize that a clean environment can help you focus a lot better and will also assist you in prolonging the life of the machines you might have in your workshop.

In order to make sure that the bit is centered properly, you should use a bit of drying lubricant and spray the inside of the chuck with it. All you have to do is use the lubricant, then loosen and tighten the screws a couple of times, leave the solution to drip out and then wipe everything nice and clean with just a rag. I don’t think it can get simpler than this, so these are my pieces of advice. If you have any extra ones, be sure to let me know about them. Also, if you’re tired of your old model and you want to buy a new drill press, I recommend gathering some info from this site: